Panty sanitary napkin machinery is generally repaired by special personnel. What should we pay attention to when using panty sanitary napkin equipment?

Precautions for the use of panty sanitary napkin machinery

(1) Make sure that the panty sanitary napkin machine is powered on, and then turn on the power.

(2) When preparing the product packaging, open the packing bag strip and put the packed bag into the studio. The seal shall be placed flat on the silicone rubber strip. Don't overlap the bags. Turn over the pressure strip of the packing bag and press the opening of the packing bag.

(3) Press down the working chamber and close the cover. The machine will automatically complete the vacuum packaging process according to the program and open the cover automatically.

(4) If there are other circumstances that need to stop packaging, set the emergency stop switch and use the emergency stop switch correctly.

(5) After using the panty sanitary napkin machine, cut off the power supply in time, clean the machine and put it in a proper position.

Reasons why panty sanitary napkin machinery cannot seal

(1) First, check whether the heat seal switch of the panty sanitary napkin machine at the most basic position of the control panel is turned on, or whether the power supply is turned on.

(2) If it fails to seal suddenly during use, the panty sanitary napkin mechanical element may be damaged or the power connection of the heating element may be disconnected.

(3) Eliminate the above problems, check whether there is a problem with the control panel and whether the set value of heating time is correct.

(4) There is a problem with the control component and the relay is damaged during the heating time.

(5) The failure to seal may be due to a problem with the solenoid valve.

Preparation of panty sanitary napkin machinery before use

(1) Place the mechanical machine stably, check whether the cover is stable and whether it jumps automatically after releasing.

(2) Equipped with power supply suitable for model requirements.

(3) Check whether the oil level position of panty sanitary napkin mechanical vacuum pump is correct. If it is incorrect, adjust it.

(4) The machine is well grounded.

(5) Turn on the power supply, turn on the power switch, close the cover, and check whether the vacuum pump operates normally.

Like other mechanical equipment, if the screws and pipes inside are not tightened, resulting in mechanical failure of panty sanitary napkin, pay attention to fixing the pipe clamp of the barrel ring, and then tighten it with screws to reasonably ensure the operation of mechanical equipment.